Kidde ARIES Installation, Operation And Maintenance Manual page 148

3-2.5.2.4.46 How to Add One or More Control Units to a Network
Step
1 Press 0 Key
2 Enter Password
3 Press 3 Key
4 Press "Scroll" Key
5 Press 6 Key
6 Press "Scroll" Key
7 Press 4 Key
8 Press 1 Key and then press "Enter" Key to confirm
selection.
9 Use keypad to enter single node or range of
nodes and press "Enter" Key to confirm selection.
10 Press "Backspace" Key (as required)
11 Wait until "Initializing Configuration" message
disappears from the display.
August 2013
Purpose: To include additional control units in an existing network or
to start initial network communications between two or more control
units.
Note: This procedure must be performed to start network operations.
Network communications will not begin after all configurations
have been uploaded unless this procedure is performed. Use
Node No. 1 to start initial network communications.
Action
3-66
Result
Initiate menu access
Gain access to menus
Enter Set-Menu branch
Access additional options
Select "Network" option
Access additional options
Select "Add/Remove Nodes"
Select Add Node
Specify node(s) to be added and execute
procedure
Exit Menu System
Initialization complete
P/N 06-236530-001