Ricoh M022 Service Manual page 1013

CÓPIA NÃO CONTROLADA
Access Point
This is the number of the dial-up access point for RCG-M. If no setting is done for this SP
163 code, then a preset value (determined by the country selected) is used.
Default: 0
Allowed: Up to 16 alphanumeric characters
Line Connecting
This SP sets the connection conditions for the customer. This setting dedicates the line to
RCG-M only, or sets the line for sharing between RCG-M and a fax unit.
[0 to 1 / 0 / 1 /step]
0: Sharing Fax
164
1: No Sharing Fax
• If this setting is changed, the copier must be cycled off and on.
• SP5816 187 determines whether the off-hook button can be used to interrupt a RCG-
M transmission in progress to open the line for fax transaction.
173 Modem Serial Number
Retransmission Limit
Normally, it is best to allow unlimited time for certification and ID2 update requests, and
for the notification that the certification has been completed. However, RCG -M generates
174
charges based on transmission time for the customer, so a limit is placed upon the time
allowed for these transactions.
If these transactions cannot be completed within the allowed time, do this SP to cancel the
time restriction.
FAX TX Priority
This SP determines whether pushing the off-hook button will interrupt a RCG-M transmission
in progress to open the line for fax transaction. This SP can be used only if SP5816 164 is
187
set to "0".
[0 or 1/ 0 / - ]
0: Disable, 1: Enable
200 Manual Polling
CÓPIA NÃO CONTROLADA
This SP displays the serial number registered for the RCG
-M.
-
- Executes the manual polling.
System SP5-xxx
3
267