SIP Media Gateway commands
Debugging commands
debug voip dial-peer
Use this command to debug VoIP dial peers. Use the no form of this command to disable the
debug messages.
Syntax
[no] debug voip dial-peer
Example
AG# debug voip dial-peer
debug voice cc
Use this command to debug the VoIP call control engine. Use the no form of this command to
disable the debug messages. If no parameters are specified, the AG2330 outputs all message
types.
The most common option to use is debug voice cc routing, which acts as a type of trace
command, displaying the dial-peer matching. Verify the status of the dial peer first using the
show dial-peer voice.
If debugging the routing does not identify the problem, then enable specific debugs. Enabling
all debugs at once provides too much output to provide meaningful information.
Syntax
[no] debug voice cc [sip | isdn | cas | pots | fsm | media | routing
| msm | all]
Table 407: Variable definitions
sip
isdn
cas
pots
fsm
370
Command Line Reference
Variable
Comments? infodev@avaya.com
Value
Enables SIP adaptor specific debugs.
Enables ISDN adaptor specific debugs.
Enables CAS adaptor specific debugs.
Enables POTS adaptor specific debugs.
Enables state machine specific debugs.
August 2013