Example
AG/configure/voice/service/voip/sip# rel1xx disable
show voice service voip
Use this command to display global VoIP properties.
Syntax
show voice service voip
Example
AG# show voice service voip
ISDN configuration commands for voice
link pri_t1 | pri_e1 | bri voice
The AG2330 supports ISDN PRI (on T1 ports) and BRI signaling for data and voice. The CLI
configuration commands are identical for the data and voice configurations, except for a voice
parameter available in the link command, as shown below. In addition, when configuring
ISDN voice ports, you must specify the network clock using the network-clock-select
command.
Use the following command to link a bundle to an ISDN port for voice.
Syntax
link {pri_t1 <slot/port[<:timeslots>]> | pri_e1 <slot/
port[<:timeslots>]> | bri <slot/port:links>} voice <overlap-receive>
Table 344: Variable definitions
pri_e1 <slot/port[<:timeslots>]>
pri_t1 <slot/port [<:timeslots>]>
bri <slot/port:links>
Command Line Reference
Variable
Value
Specifies an E1 link and timeslots for ISDN
PRI.
Specifies T1 link and timeslots (1-23) for
ISDN PRI.
Specifies ISDN BRI link. You can specify 1
link (64Kb/s) or 2 (128 Kb/s).
show voice service voip
August 2013
319