configure module t1 linemode dsx
Use this command to set the amount of T1 signal equalization based on the cabling distance
to the DSX cross-connec.
Syntax
linemode dsx [cable-length] <length>
Table 53: Variable definitions
Variable
<length>
Example
AG/configure/module/t1 (3/1)# linemode dsx 2
configure module t1 loopback_framing
Use this command to set the loopback framing mode for in-band loopcode to overwriting or
insertion.
Syntax
loopback_framing {overwrite | insert}
Table 54: Variable definitions
Variable
overwrite
insert
Example
AG/configure/module/t1 (3/1)# loopback_framing insert
Command Line Reference
configure module t1 linemode dsx
Value
1: specifies cable length of 0-110 2: specifies
cable length of 110-220 3: specifies cable
length of 220-330 4: specifies cable length of
330-440 5: specifies cable length of 440-550
6: specifies cable length of 550-660
Value
Overwriting of framing for in-band loopcode
for T1 (default).
Insertion of framing for in-band loopcode for
T1.
August 2013
75