Chapter 23: Chassis QoS commands
clear qos chassis
Use this command to clear QoS statistics for the specified interface and/or class map. Execute
this command to clear the statistics information for the specified interface. If class map is
specified then it clear statistics for the class map only.
Syntax
clear qos chassis <interface-type> <interface-name> [pvc <pvc-id>]
[class <class-map-name>]
Table 197: Variable definitions
<interfacetype>
<interfacename>
[class-map <class-map-name>]
[pvc < pvc-id>]
Example
AG# clear qos chassis ethernet 0/3 class class1
configure interface qos chassis enable
Use this command to enable features that are specified in a policy map. For the features
specified in the policy map to be applied to an interface, you must explicitly enable the features
using this command.
Important:
On Frame Relay bundles, whenever a PVC is created, it uses all the available or unassigned
bandwidth. When CBQ is enabled either manually or using auto QoS, subsequent PVC
creation fails because there is no available bandwidth. To avoid this scenario, you must
Command Line Reference
Variable
Value
Can be Ethernet, bundle, tunnel, vlan or
crypto.
Name of the interface.
Class map name to clear the statistics.
String(1-19)
PVC identifier for the FR interface.
Mandatory parameter for FR interfaces.
August 2013
203