SIP Media Gateway commands
[no]
Example
AG/configure/module/e1 (1/1)#cas-group timeslots 2 r2-digital r2-
compelled
T1 CAS configuration command
configure module t1 cas-group
Use this command to specify the DS0 time slots that make up a logical voice port on a T1
module and to specify CAS as the signaling type by which the logical voice port communicates
with the PBX or PSTN.
This command assumes that the T1/E1 module is in T1 mode. If it is not, you can set the module
to T1 mode by entering the system carrier-type <slot> t1 command and then
rebooting the AG2330.
Syntax
[no] cas-group timeslots <timeslot-list> {em-delay-dial | em-wink-
start | em-immediate-start }
Table 350: Variable definitions
<timeslot-list>
324
Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Secure Router to turn off the tones. The
tones are compelled to stay on until they are
turned off.
Removes the group and signaling settings.
To modify an existing E1 CAS configuration,
you must first remove the existing
configuration using this option.
Value
Lists time slots in the DS0 group. Valid
values are a single time-slot number, a single
range of numbers, or multiple ranges of
numbers separated by commas, within the
range of 1 to 24 for T1. Examples are as
follows:
• 2
• 1-15,17-24
August 2013