Configure Sla Schedule; Show Sla Profile - Avaya 2330 Reference Manual

SLA commands
Example
AG/configure/sla/profile 1# udp-v6-jitter delay 2001::3

configure sla schedule

Use this command to configure the SLA profile schedule.
Syntax
sla schedule <sla-profile> [life <time-inmin>] [start <time-in-min>]
Table 285: Variable definitions
Variable
<sla-profile>
[life <time-inmin>]
[start <time-in-min>]
[no]
Example
AG/configure# sla schedule 1 life 5 start 5

show sla profile

Use this command to show the SLA profile schedule.
Syntax
show sla profile [<1-1000>] [detail]
Table 286: Variable definitions
Variable
[<1-1000>]
262 Command Line Reference
Value
This parameter specifies which sla profile
has to be scheduled. Valid : 1-1000
It is the time until which the sla profile will be
in Active state. Valid: 1 – 1440. Default value:
Forever (means SLA will be active forever till
no sla schedule command is given)..
This specifies the time after which the profile
will be scheduled. Valid: 0 – 60. Default
value: 0.
Stop the scheduling of the SLA profile.
Value
Specifies the SLA profile to display.
Comments? infodev@avaya.com
August 2013