Vlan Classification Ipv4 - Avaya 2330 Reference Manual

VLAN commands
Table 89: Variable definitions
<id>
<protocol>
[no]
<encapsulation>
Example
AG/configure/vlan classification# rule 3 protocol mpls en llcsnap

vlan classification ipv4

After you have defined protocol rules, you can apply those rules to an interface. Use this
command to apply an IPv4 subnet-based classification rule to an interface.
Important:
You can apply VLAN classification rules only on hybrid ports.
110 Command Line Reference
Variable
Comments? infodev@avaya.com
Value
Specifies the VLAN classifier rule ID. Valid
values are 1 to 12.
The protocol parameter is either a number
(from 0 to 65535), or one of the following:
• ipv4
• ipv6
• mpls
• arp
• rarp
• vlan-tagged
• appletalk
• ipx
• pppoe-disc
• pppoe-session
Removes a protocol-based VLAN
classification rule.
Specifies the encapsulation type. Enter one
of the following:
• ethv2
• llcsnap
• llc
August 2013