Configure Sla Profile Udp-V6-Echo - Avaya 2330 Reference Manual

SLA commands
[packet-spacing <value>]
[packet-size <value>]
[packet-count <value>]
[periodicity <value>]
[dscp <value>]
[ip-precedence <value>
[tos-byte <value>]
[ttl <value>]
[no]
Example
AG/configure/sla/profile 1# udp-jitter delay 10.12.34.5

configure sla profile udp-v6-echo

To calculate RTT delay for UDPv6 packets to the destination system, use this command to
configure the IPv6 address and port number of destination system.
Syntax
[no] udp-v6-echo <ipv6-address> [port <7|50002>]
Table 283: Variable definitions
<ipv6-address>
[port <7|50002>]
[no]
260 Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Time spacing between two consecutive
packets in mill seconds. Valid: 10 – 5000.
Default: 20
Size of the packet in bytes. Valid: 1 – 1400.
Default: 80
Number of packets to be sent. Valid: 1 – 100.
Default: 20
After every specified periodicity minutes the
sla will be scheduled again. Valid: 10 – 60.
Default: 10
DSCP value to be marked on the packets.
Valid: 0 – 63. Default: 0
IP-precedence to be marked. Valid: 0 – 7.
Default: 0
ToS for the packets. Valid: 0 – 255. Default:
0
Time to Live for the packet. Valid: 1 – 255.
Default: 64
Removes all the udp-jitter configurations.
Value
IPv6 address of the destination system.
The port to which the SLA packets will be
sent. Valid: 7 or 50002. Default: 50002
Removes all the udp-v6-echo
configurations.
August 2013