Cli Commands For Upgrading G250 Firmware Via Ftp/Tftp; Example Upgrade Via Ftp/Tftp Using The Cli - Avaya G250 Installing And Upgrading

Upgrading the G250 firmware

CLI Commands for upgrading G250 firmware via FTP/TFTP

You can use CLI commands to upload an upgrade file to the G250. For each of these
commands, include the full path of the file and the IP address of the FTP or TFTP host as
parameters. You must use the specific path to the file on the FTP or TFTP server according to
the home directory of the service (FTP or TFTP) that you are using. When you enter the
command, the CLI prompts you for a username and password.
Use the copy ftp module command, followed by the module number of the module you
●
want to upgrade, to upgrade the firmware on a media module from an FTP server.
Use the copy ftp SW_imageA command to upgrade the G250 firmware into Bank A
●
from an FTP server.
Use the copy ftp SW_imageB command to upgrade the G250 firmware into Bank B
●
from an FTP server.
Use the copy tftp module command, followed by the module number of the module
●
you want to upgrade, to upgrade the firmware on a media module from a TFTP server.
Use the copy tftp SW_imageA command to upgrade the G250 firmware into Bank A
●
from a TFTP server.
Use the copy tftp SW_imageB command to upgrade the G250 firmware into Bank B
●
from a TFTP server.

Example upgrade via FTP/TFTP using the CLI

To upgrade the firmware of an MM340 media module in slot 2 from a TFTP server with the IP
address 192.1.1.10, where the home directory is c:\home\ftp\ and the upgrade file is located in
the directory c:\home\ftp\version, use the following command:
copy tftp module \version\mm340v51.fdl 192.1.1.10 2
Note:
When uploading firmware from the S8300, use only the file name, without the
Note:
directory path, in the command line. Otherwise, the procedure will fail. For
instance, in the example above, you must use the following command:
copy tftp module mm340v51.fdl 192.1.1.10 2
Note:
When uploading firmware from the S8300 using TFTP, you may need to enable
Note:
TFTP service in the Set LAN Security parameters of the S8300 web page.
The following example uploads a firmware version with the path and file name C:\G250.net from
an FTP server with the IP address 149.49.134.153 to Bank A of the G250:
copy ftp SW_imageA \G250.net 149.49.134.153
74 Installing and Upgrading the Avaya G250 Media Gateway