Configure Voice Dsp Dtmf-Level; Configure Voice Service Voip Codec - Avaya 2330 Reference Manual

SIP Media Gateway commands

configure voice dsp dtmf-level

Use this command to configure the DTMF level.
Syntax
[no] dtmf-level <dtmf-level>
Table 336: Variable definitions
<dtmf-level>
[no]
Example
AG/configure/voice/dsp#dtmf-level -40

configure voice service voip codec

Use this command to specify a list of preferred codecs to use on a system.
If you do not specify preferred codecs to use, the AG2330 uses G.711 u-law as preference 1
and G.711 a law as preference 2 by default. When you specify any preferred codecs, your
configuration overrides both of these settings.
Syntax
codec <preference> {g711alaw | g711ulaw | g729r8 | g723r53 | g723r63|
g726r16| g726r24| g726r32} [<bytes>]
Table 337: Variable definitions
<preference>
{g711alaw | g711ulaw | g729r8 | g723r53 |
g723r63| g726r16| g726r24| g726r32}
314 Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Specifies the DTMF level adjustment in
0.1dB steps (enter as step-in-dB*10). Range
is -60 - 70.
Resets the dtmf-level to 0dB.
Value
Specifies the order of preference, with 1
being the most preferred and 8 being the
least preferred.
Specifies the codec preferred. Values are as
follows:
• g711alaw: G.711 a law 64,000 bps
• g711ulaw: G.711 mu-law 64,000 bps
August 2013