Show Sip-Ua Register Status; Caller Id Configuration Commands For Fxs And Fxo Ports; Configure Voice-Port Caller-Id Alerting Ring - Avaya 2330 Reference Manual

SIP Media Gateway commands
ipv4:<ip-addr>
[:port-num]
[expires <registration-time>]
[no]
Example
AG/configure/sip-ua# registrar ipv4:10.8.17.40 expires 3600

show sip-ua register status

Use this command to display the status of E.164 numbers that the SIP Media Gateway has
registered with an external primary SIP registrar.
Syntax
show sip-ua register status
Example
AG# show sip-ua register status

Caller ID configuration commands for FXS and FXO ports

configure voice-port caller-id alerting ring

Use this command to set the ring-cycle method for receiving caller ID information for on-hook
(Type 1) Caller ID at a receiving FXO or a sending FXS voice port.
This setting is determined by the Bellcore/Telcordia or ETSI standard that your telephone
service provider uses for caller ID. Use it on FXO loop-start and ground-start voice ports where
caller ID information arrives and on FXS voice ports from which caller ID information is sent.
This setting must match on the sending and receiving ends on both ends of the telephone line
connection.
By default, caller ID alerting displays after the first ring at the receiving station.
344 Command Line Reference
Variable
Comments? infodev@avaya.com
Value
Specifies the IP address of the SIP registrar
server.
Specifies the SIP registrar server port
number to use.
Specifies the default registration time, in
seconds. Range is 60 to 65535. Default
value is 3600.
Disables registration of E.164 numbers.
August 2013