Configure Interface Ipv6 Dhcp Relay; Configure Interface Ipv6 Dhcp Server - Avaya 2330 Reference Manual

DHCPv6 commands
Example
AG/configure/interface/ethernet (6/13)# ipv6 dhcp client pd pdname

configure interface ipv6 dhcp relay

Use this command to enable DHCPv6 relay on this interface to listen for client messages.
The current implementation can enable the relay on only one interface at any time.
If you have to change the server IPv6 address, then disable the relay and re-enable it with the
required server IPv6 address. The "no" form of the command disables the relay.
Syntax
[no] ipv6 dhcp relay server-ipv6 <server-ipv6-address> <interface-
name>
Table 163: Variable definitions
<server-ipv6-address>
<interface-name>
Example
AG/configure/interface/ethernet (6/13)# ipv6 dhcp relay server-ipv6
fe80::99 ethernet0/4

configure interface ipv6 dhcp server

Use this command to enable DHCPv6 client on the specified interface. The current
implementation can enable DHCPv6 server on only one interface at any time.
The rapid-commit option and the preference value can be modified even after the server is
enabled.
If this command is executed with a pool name, for example, xyz, that does not exist, the
command will still succeed, but the server will not be able to provide any parameter to the
client. At the same time, it is possible to configure this new pool (the same xyz) after enabling
172 Command Line Reference
Variable
Comments? infodev@avaya.com
Value
Specifies the IPv6 address of the DHCPv6
server to which the client requests have to be
forwarded.
If the DHCPv6 server address is a global
scope address, this parameter is not
required. If the DHCPv6 server address is a
link local scope address, this parameter is
mandatory.
August 2013