Configure Mac Packet-Filter Delete; Configure Packet-Filter-Group; Show Ip Packet-Filter - Avaya 2330 Reference Manual

Packet filter commands
[dmask <dst-mask>]
[ethertype <ether-type>]
[cos <cos-value>]
[vlan <vlan-id>]
[no]
Example
AG/configure/mac/packet-filter macfilter1# add deny 0000.4700.0011
any smask ffff.ffff.ffff

configure mac packet-filter delete

Use this command to delete rules from the MAC packet filter.
Syntax
delete <1-65535>
Example
AG/configure/mac/packet-filter macfilter1# delete 1

configure packet-filter-group

Use this command to apply a packet filter to an interface. With VLANs, you can apply one IPv4
and one IPv6 packet filter to an interface in either direction . With Ethernet interfaces, you can
apply one IPv4, one IPv6, and one MAC packet filter in the inbound direction only.
Syntax
packet-filter-group <interface-name> [in | out] {[mac <mac-packet-
filter>] | [ip <ip-packet-filter>] | [ipv6 <ipv6-packet-filter>]}
Example
AG/configure# packet-filter-group ethernet0/3 in ipv6 ipv6filter1

show ip packet-filter

Use this command to show IPv4 packet filter rules.
272 Command Line Reference
Specifies MAC destination mask.
Specifies the Ethernet type: arp, mpls, aarp,
ppp or Ethernet type value in hex.
CoS value. Range is 0-7.
Specifies the VLAN ID. Range is 1-4000.
Removes the specified packet filter.
Comments? infodev@avaya.com
August 2013