Fxo Port Configuration Commands; Configure Voice-Port Ani Mapping - Avaya 2330 Reference Manual

{em-delay-dial | em-wink-start | em-
immediate-start }
[no]
Example
AG/configure/module/t1 (3/1)# cas-group timeslots 1-4 em-delay-dial

FXO port configuration commands

configure voice-port ani mapping

Use this command to preprogram the Numbering Plan Area (NPA), or area code, into a single
Multi Frequency (MF) digit.
By default, no ANI mapping is configured.
Syntax
[no] ani mapping <npd-value> <npa-number>
Table 351: Variable definitions
<npd-value>
Command Line Reference
Variable
Variable
FXO port configuration commands
Value
• 1-23
• 2,4,6-12
Specifies the type of signaling for the CAS
group. The ear and mouth (E&M) interface
allows connection for PBX trunk lines (tie
lines) and telephone equipment. Valid types
are as follows:
• em-delay-dial: The originating endpoint
sends an offhook signal and then waits for
an off-hook signal followed by an on-hook
signal from the destination.
• em-immediate-start: E&M immediate
start.
• em-wink-start: The originating endpoint
sends an offhook signal and waits for a
wink-start from the destination.
Removes the group and signaling settings.
Value
Specifies the value of the Numbering Plan
Digit (NPD). Range is 0 to 3.
August 2013 325