Configure Dial-Peer Voice Voip Fax Rate; Configure Dial-Peer Voice Voip Modem Passthrough - Avaya 2330 Reference Manual

SIP Media Gateway commands

configure dial-peer voice voip fax rate

Use this command to establish the rate at which a fax is sent to a specified dial peer.
When applying the fax rate, the AG2330 first applies the rate specified for the dial peer, and if
the transmission is failing, applies the global rate.
Syntax
no fax rate {2400 | 4800 | 7200 | 9600 | 12000 | 14400| voice}
Table 392: Variable definitions
{2400 | 4800 | 7200 | 9600 | 12000 | 14400|
voice}
[no]
Example
AG/configure/dial-peer/voice/voip 20# fax rate 12000

configure dial-peer voice voip modem passthrough

Use this command to enable modem pass-through over VoIP for a specific dial peer.
By default, the dial-peer uses the globally configured codec.
Syntax
[no] modem passthrough {system | codec {g711ulaw | g711alaw }}
Table 393: Variable definitions
system
codec {g711ulaw | g711alaw }
358 Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Specifies the baud rate.
Resets the fax rate to the globally defined
value: 9600.
Value
Uses the global configuration that was set
using the global modem passthrough
command.
Specifies which high-bandwidth codec the
modem stream uses:
• g711ulaw: uses the G.711 u-law codec.
• g711alaw: uses the G.711 a-law codec.
August 2013