SIP Media Gateway commands
Syntax
[no] session target {<ipv4-dest-address> | sip-server}
Table 368: Variable definitions
<ipv4-dest-address>
sip-server
[no]
Example
AG/configure/dial-peer/voice/voip 20# session target 10.10.1.1
configure voice service voip dtmf-relay rtp-nte
Use this command to specify how the SIP gateway relays dual tone multifrequency (DTMF)
tones between telephony interfaces and an IP network.
By default, DTMF tones are disabled and sent in-band.
Syntax
[no] dtmf-relay rtp-nte
Table 369: Variable definitions
rtp-nte
[no]
340
Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Specifies the IP address of the dial peer to
receive calls.
Specifies the global Session Initiation
Protocol (SIP) server that is the destination
for calls from this dial peer. If you first define
the SIP server IP address using the
configure sip-ua sip-server
command, you can then enter the
target sip-server
peer rather than repeatedly entering the full
SIP server IP address for each dial peer
(using
session target <ipv4-
dest-address>
).
Resets to the default setting: no session
target defined.
Value
Forwards DTMF tones by using Real-Time
Transport Protocol (RTP) with the Named
Telephone Event (NTE) payload type.
DTMF tones are disabled and sent in-band.
session
option for each dial
August 2013