SIP Media Gateway commands
Example
AG/configure/voice-port (2/1)# echo-cancel enable
configure voice-port input gain
Use this command to configure a specific input gain value or enable automatic gain control.
By default, the input gain value is set to 0 decibels.
Syntax
[no] input gain <decibels>
Table 380: Variable definitions
<decibels>
[no]
Example
AG/configure/voice-port (7/2/1)# input gain 6
configure voice-port output attenuation
Use this command to configure a specific output attenuation value.
The default attenuation value is 0 decibels.
Syntax
[no] output attenuation <decibels>
Table 381: Variable definitions
<decibels>
350
Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Specifies the gain, in decibels (dB), to be
inserted at the receiver side of the interface.
Valid values are –6, 0, or 6. The default is
0.
Disables the selected amount of inserted
gain.
Value
Specifies the attenuation, in decibels (dB), at
the transmit side of the interface. Valid
values are –6 or 0. The default is 0.
August 2013