Configure Interface Qos Chassis Service-Policy - Avaya 2330 Reference Manual

Chassis QoS commands
[minth <percent>]
[maxth <percent>]
[dscp <0-63>]
[mpd <1-15>]
[no]
Example
AG/configure/interface/bundle wan1/qos/chassis# red minth-red 30
maxth-red 60 mpd-red 5 minth-yellow 40 maxth-yellow 80 mpd-yellow 4
minth-green 60 maxth-green 95 mpd-green 6

configure interface qos chassis service-policy

Syntax
After you have configured a policy map, use this command to assign it to one or more
interfaces.
The policy map can be associated with an interface in the inbound or outbound direction. When
you associate a policy map with an interface, an instance of the policy map is instantiated over
the interface in the specified direction. If you change the policy map after applying it to the
interface, the changes are applied across all associated interfaces.
[no] service-policy {input | output} <policy-name> [pvc <PVC>]
Table 201: Variable definitions
<interface-type> <interface-name>
{input | output}
<policy-name>
206 Command Line Reference
Variable
Variable
Comments? infodev@avaya.com
Value
Minimum Threshold for DS-RED. Valid
Range: 1-100.
Maximum Threshold for DS-RED. Valid
Range: 1-100.
DiffServ Codepoint for DS-RED. Valid
Range: 0-63/string.
Mark Probability Denominator (as power of
2) for DS-RED. Valid Range: 1-15.
Resets the WRED parameters to their
default values, which depends on the
interface, and removes the DS-RED
parameters if specified.
Value
Interface type can be Ethernet, bundle,
tunnel, vlan or crypto.
Specifies whether the policy map is applied
in the inbound direction or outbound
direction.
The policy map name that has to be
applied.
August 2013