Fxs Port Configuration Commands; Configure Voice-Port Signal Did - Avaya 2330 Reference Manual

kp-npd-nxx-xxxx-st
[no]
Example
AG/configure/voice-port (7/2/1)# signal cama kp-0-npa-nxxx-xxxx-st

FXS port configuration commands

configure voice-port signal did

Use this command to enable direct inward dialing (DID) on an FXS voice port. By default, DID
is disabled and the voice port uses loop-start signaling.
Syntax
[no] signal did {immediate-start | wink-start | delay-dial}
Table 355: Variable definitions
immediate-start
wink-start
delay-dial
Command Line Reference
Variable
Variable
FXS port configuration commands
Value
Specifies 8-digit ANI transmission. The I field
consists of a single-digit NPD-to-NPA
mapping. The NPD table is preprogrammed
in the sending and receiving equipment (on
each end of the MF trunk); for example: 0=
415, 1=510, 2=650, 3=916 05551234 = (415)
555-1234, 15551234 = (510) 555-1234, and
so on. When the calling party number of
415-555-0122 places a 911 call, and the
AG2330 has an NPD (0)-to-NPA (415)
mapping, the NPA signaling format is
received by the selective gateway at the
central office (CO). NPD range is from 0 to
3.
Removes the configured 911 transmission
selection.
Value
Enables immediate-start signaling on the
FXS/DID voice port.
Enables wink-start signaling on the FXS/DID
voice port.
Enables delay-dial signaling on the FXS/DID
voice port.
August 2013 329