Configure Sip-Ua Transport - Avaya 2330 Reference Manual

Table 328: Variable definitions
dns:<host-name>
ipv4:<ip-addr>
[no]
Example
SR/configure/sip-ua# sip-domain dns:avaya.com

configure sip-ua transport

Use this command to specify whether the SIP signaling messages on inbound calls are
received through the SIP TCP socket or UDP socket. By default, both TCP and UDP are
enabled.
If the transport parameter is changed, any POTS lines that are currently registered with the
SIP Server are re-registered using the new transport parameter.
Syntax
[no] transport {tcp | udp}
Table 329: Variable definitions
tcp
udp
[no]
Example
AG/configure/sip-ua# transport udp
Command Line Reference
Variable
Variable
Value
Specifies a valid DNS host name for the
global SIP server in the following format:
name.gateway.xyz.
Sets the global SIP domain to an IP address.
A valid IP address takes the following format:
xxx.xxx.xxx.xxx.
Removes the configured domain address.
Value
Specifies that the SIP dial peer uses the TCP
transport layer protocol (on port 5060).
Specifies that the SIP dial peer uses the UDP
transport layer protocol (on port 5060). This
is the default.
Resets the transport protocol to the default
value: UDP, TCP.
configure sip-ua transport
August 2013 307