Change The Fuel Hoses - Deutz Diesel Models - Genie S-60 Service Manual

Section 4 • Scheduled Maintenance Procedures
TABLE D PROCEDURES
2 Remove the fuel filter/water separator with a
filter wrench.
a
a oil filter
b fuel filter/water separator
3 Fill the new filter with fresh diesel fuel and apply
a thin layer of diesel fuel to the new fuel filter
gasket.
4 Install the new filter and tighten it securely by
hand. Clean up any diesel fuel that might have
spilled during the procedure.
5 Turn the manual fuel shutoff valve, located at
the fuel tank, to the
6 Start the engine from the ground controls and
inspect the fuel filter for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
4 - 70
position.
OPEN
Genie S-60 & Genie S-65
D-10
Change the Fuel Hoses -
Deutz Diesel Models
Maintaining the fuel hoses in good condition is
essential to safe operation and good engine
performance. Failure to detect a worn, cracked or
b
leaking fuel hose may cause an unsafe operating
condition.
1 Remove the 2 engine pivot plate retaining bolts
and swing the engine out away from the
machine to access the fuel hoses.
a
Third Edition • First Printing
Explosion and fire hazard. Engine
fuels are combustible. Replace the
fuel hoses in an open, well-
ventilated area away from heaters,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
Component damage hazard. Be
sure the fuel hoses are routed the
same way the original hoses were.
Perform this procedure with the
engine off and cooled.
b b
a engine pivot plate
b pivot plate retaining bolts
c oil drain hose
d air baffle
Part No. 65196
c