Genie S-60 Service Manual page 224

Third Edition • First Printing
9 Remove the fasteners from the drive speed limit
switch mounted on the side of the cable track at
the pivot end of the boom. Do not disconnect
the wiring.
10 Remove the fasteners from the side panel on
the lower cable track, then remove the panel.
Pull all of the cables and hoses out of the
channel.
11 Place blocks between the upper and lower
cable tracks and secure the upper and lower
tracks together.
Crushing hazard. If the upper and
lower cable tracks are not properly
secured together, the cable track
could become unbalanced and fall
when it is removed from the
machine.
12 Remove the mounting fasteners from the large
cable track guide at the platform end of the
cable track. Remove the guide.
13 Remove the hose and cable clamp at the
platform end of the cable track.
14 Attach a lifting strap from an overhead crane to
the cable track.
15 Remove the cotter pin and clevis pin from the
upper cable track at the platform end.
Always replace the cotter pin with
a new one when removing a clevis
pin.
16 Remove the mounting fasteners that attach the
lower cable track to the boom.
Part No. 65196
17 Remove the cable track from the machine and
place it on a structure capable of supporting it.
How to Repair the Cable Track
1 Remove the boom cable track. See 4-1, How to
Remove the Boom Cable Track.
2 Visually inspect the cable track and determine
which 4 link section needs to be replaced.
Genie S-60 & Genie S-65
Section 7 • Repair Procedures
BOOM COMPONENTS
Crushing hazard. The cable track
could become unbalanced and fall
if it is not properly attached to the
overhead crane.
Component damage hazard.
The boom cable track can be
damaged if it is twisted.
Component damage hazard.
The boom cable track can be
damaged if it is twisted.
A cable track repair kit is available
through the Genie Industries
Service Parts Department,
part no. 46677. The kit includes a
4 link section of cable track,
fasteners, other miscellaneous
parts and detailed instructions.
7 - 21