Check The Oil Level In The Drive Hubs - Genie S-60 Service Manual

Section 4 • Scheduled Maintenance Procedures
TABLE B PROCEDURES
B-5
Check the Oil Level in
the Drive Hubs
Failure to maintain proper drive hub oil levels may
cause the machine to perform poorly and
continued use may cause component damage.
Drive Hubs
1 Drive the machine to rotate the hub until the
plugs are located one on top and the other at
90 degrees.
2 Remove the plug located at 90 degrees and
check the oil level.
Result: The oil level should be even with the
bottom of the plug hole.
3 If necessary, remove the top plug and add oil
until the oil level is even with the bottom of the
side plug hole.
4 - 34
4 Apply pipe thread sealant to the plug(s), and
then install the plug(s) in the drive hub.
5 Repeat this procedure for each drive hub.
Drive hub oil
Capacity
Type: SAE 90 multipurpose hypoid gear oil - API service
classification GL5
Turntable Rotate Drive Hub
1 Remove the plug located on the side of the hub
and check the oil level.
Result: The oil level should be even with the
bottom of the plug hole.
b
Genie S-60 & Genie S-65
Third Edition • First Printing
a drive hub
b plug
Part No. 65196
44 fl oz
1.30 liters
a