Inspect For Damage And Loose Or Missing Parts - Genie S-60 Service Manual

Section 4 • Scheduled Maintenance Procedures
TABLE A PROCEDURES
A-3
Inspect for Damage and Loose or
Missing Parts
Daily machine condition inspections are essential
to safe machine operation and good machine
performance. Failure to locate and repair damage,
and discover loose or missing parts may result in
an unsafe operating condition.
1 Inspect the entire machine for damage and
improperly installed or missing parts including:
· Electrical components, wiring and electrical
cables
· Hydraulic hoses, power units, fittings, cylinders
and manifolds
· Fuel and hydraulic tanks
· Drive and turntable motors and drive hubs
· Boom wear pads
· Tires and wheels
· Engine and related components
· Limit switches, alarms, horn and beacon
· Nuts, bolts and other fasteners
· Platform entry mid-rail or gate
4 - 6
Check entire machine for:
· Cracks in welds or structural components
· Dents or damage to machine
· Battery and connections
· Compartment covers and latches
Be sure that all structural and other critical
components are present and all associated
fasteners and pins are in place and properly
tightened.
After you complete each inspection, be sure that all
compartment covers are in place and secured.
Genie S-60 & Genie S-65
Third Edition • First Printing
Part No. 65196