Genie S-60 Service Manual page 91

Third Edition • First Printing
Turntable Rotate Drive Hub:
1 Secure the turntable from rotating with the
turntable rotation lock pin.
unlocked
2 Remove the motor/brake mounting bolts, and
then remove the motor and brake from the drive
hub and set them to the side.
Component damage hazard.
Hoses can be damaged if they are
kinked or pinched.
a motor
b motor/brake mounting bolts
c brake
d drive hub
e drive hub mounting bolts
Part No. 65196
3 Remove the drive hub mounting bolts, and use
4 Remove the plug from the side of the drive hub.
5 Install the drive hub. Torque the drive hub
6 Install the brake and motor onto the drive hub.
7 Fill the hub with oil from the side hole until the
locked
8 Adjust turntable rotation gear backlash. See
Turntable rotate drive hub
Oil capacity
Type: SAE 90 multipurpose hypoid gear oil - API
service classification GL5
Genie S-60 & Genie S-65
Section 4 • Scheduled Maintenance Procedures
TABLE D PROCEDURES
a lifting device to remove the drive hub from the
machine.
Then drain the oil from the hub.
mounting bolts to 180 ft-lbs (244 Nm).
Torque the motor/brake mounting bolts to
180 ft-lbs (244 Nm).
oil level is even with the bottom of the hole.
Apply pipe thread sealant to the plug. Install the
plug.
13-1, How to Adjust the Turntable Rotation
Gear Backlash.
17 fluid ounces
0.51 liters
4 - 65