Oscillate Function Inoperative - Genie S-60 Service Manual

Third Edition • First Printing
Oscillate
Function
Inoperative
Be sure all other
functions operate
normally.
Part No. 65196
bad
Remove the chassis
cover at the non-steer
end. Check the linkage
for damage or improper
linkage adjustment. See
Repair section, 11-6
How to Set Up the
Directional Valve
Linkage.
good
Install a 0 to 2000 psi
(138 bar) pressure
less than
gauge at the quick
950 psi
disconnect coupling on
the oscillate manifold.
Disconnect the oscillate
linkage from non-steer
axle. Start the engine
and manually activate
the directional valve.
Check the pressure.
950 psi
Consult Genie Industries
Service Department.
Genie S-60 & Genie S-65
Section 5 • Troubleshooting Flow Charts
Re-adjust or replace
linkage.
Adjust the sequence
valve. See Repair
procedure 11-5, How to
Adjust the Oscillate
Sequencing Valve
Pressure OR consult
Genie Industries Service
Department.
Chart 25
5 - 55