Grease The Turntable Rotation Bearing And Rotate Gear; Perform Engine Maintenance - Deutz 1011F Models - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-12
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that this procedure be
performed every 100 hours of operation. Perform
this procedure more often if dusty conditions exist.
Frequent application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an improperly greased bearing and gear will
result in component damage.
1 Raise the boom enugh to access the turntable
gearing.
2 Locate the grease fitting on the platform end of
the engine side bulkhead.
3 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of
4 to 5 inches / 10 to 13 cm at a time and repeat
this step until the entire bearing has been
greased.
4 Apply grease to each tooth of the drive gear,
located under the turntable.
Grease specification
Chevron Ultra-duty grease, EP NLGI 2 (lithium based)
or equivalent
3 - 14
A-13
Perform Engine Maintenance -
Deutz 1011F Models
Engine specifications require that this procedure
be performed after the first 125 hours.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life.
Failure to perform the maintenance procedures
can lead to poor engine performance and
component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz 1011F Operation Manual
( Deutz part number 0297 9683).
Deutz 1011F Operation Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fasteners
located under the engine tray. Loosen the pivot
fastener located at the platform end of the
engine tray. Swing the engine tray out and
away from the machine and secure it from
moving.
S-40 • S-45
October 2013
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
Part No. 102521
52883