Wheel Brake - Genie S-60 Service Manual

Section 7 • Repair Procedures
NON-STEERING AXLE COMPONENTS
17-3

Wheel Brake

How to Remove a Wheel Brake
When removing a hose assembly
or fitting, the O-ring on the fitting
and/or hose end must be replaced
and then torqued to specification
during installation.
Refer to Section Two, Hydraulic
Hose and Fitting Torque
Specifications.
1 Remove the drive motor. See 17-1, How to
Remove a Drive Motor .
2 Tag, disconnect and plug the hydraulic hose
from the brake.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
3 Remove the brake from the machine.
7 - 80 Genie S-60 & Genie S-65
Third Edition • First Printing
Part No. 65196