Genie S-60 Service Manual page 41

Third Edition • First Printing
3 Manually activate the boom up drive limit
switch.
Result: The boom up drive limit switch arm
should move freely and spring return to center.
A distinct click should be felt and heard.
4 Visually inspect the boom extend drive limit
switch located at the end of the cable track on
the boom. Inspect for the following:
· Broken or missing roller or arm
· Missing fasteners
· Loose wiring
a
a boom extend drive limit switch (LS1)
b cable track
5 Start the engine from the ground controls.
6 Extend the boom approximately 3 feet (0.9 m).
7 Manually activate the boom extend drive limit
switch.
Result: The boom extend drive limit switch arm
should move freely and spring return to center.
A distinct click should be felt and heard.
Part No. 65196
b
Genie S-60 & Genie S-65
Section 4 • Scheduled Maintenance Procedures
TABLE A PROCEDURES
8 Turn the key switch to platform controls and
fully retract the boom.
9 Move the lift/drive selector switch to the drive
position (if equipped).
10 Press down the foot switch and slowly move the
drive controller off center.
Result: The machine should move at normal
drive speeds.
11 Move the lift/drive selector switch to the lift
position (if equipped).
12 Raise the boom to just above horizontal.
13 Move the lift/drive selector switch to the drive
position (if equipped).
14 Slowly move the drive controller off center.
Result: The machine should move at a reduced
drive speed.
15 Move the lift/drive selector switch to the lift
position (if equipped).
16 Lower the boom to the stowed position, then
extend the boom 3 feet (0.9 m).
17 Move the lift/drive selector switch to the drive
position (if equipped).
18 Slowly move the drive controller off center.
Result: The machine should move at a reduced
drive speed.
Drive speed, maximum,
raised or extended position
All models
0.3 meter per second (0.97 km/h)
1 foot per second (0.6 mph)
4 - 15