Oil Temperature And Oil Pressure Gauges - Genie S-60 Service Manual

Section 7 • Repair Procedures
DEUTZ ENGINE F4L 1011F
6-3
Oil Temperature and Oil Pressure
Gauges
The engine oil temperature gauge is an electrical
gauge. The engine oil temperature sending unit
has limit contacts that are factory set. The contacts
will close at approximately 300
the contacts close, the engine will shut off to
prevent damage and will not start until the
temperature drops below the contact point. Engine
oil temperature will be indicated on the gauge
when the key is and the Emergency Stop Button
ON
is pulled out to the position.
ON
The engine oil pressure gauge is an electrical
gauge. The engine oil pressure sending unit has
limit contacts that are factory set. The contacts will
close at approximately 7 psi (0.48 bar). When the
contacts close, the engine will shut off to prevent
damage. Engine oil pressure will be indicated on
the gauge when the engine is running.
7 - 32
o o
F (149 C). When
Genie S-60 & Genie S-65
How to Remove the Oil
Temperature and Oil Pressure
Gauge Sending Units
Perform this procedure with the
engine off.
1 Remove the fasteners from the engine side
cover, remove the cover.
2 Tag and disconnect the wiring from the desired
sending unit. Remove the sending unit from the
engine block.
3 Install the new sending unit. Do not over tighten.
4 Connect the wires to the new sending unit.
Burn hazard. Contact with hot
engine fluids or components may
cause severe burns.
Always use pipe thread sealant
when installing a sending unit.
Oil temperature sending unit specifications
Torque
Hex size
Temperature switch point
Oil pressure sending unit specifications
Torque
Hex size
Oil pressure switch point
Third Edition • First Printing
8-10 ft-lbs
11-14 Nm
13
/
16
300° F
149° C
8-10 ft-lbs
11-14 Nm
1
1 /
16
0.48 bar
Part No. 65196
inch
inch
7 psi