Wago Components - Genie S-60 Service Manual

Third Edition • First Printing
9-2
Toggle Switches
See 1-4, Toggle Switches .
9-3
®
Wago Components
How to Remove a Wago
Component
Electrocution hazard. Contact with
electrically charged circuits could
cause death or serious injury.
Remove all rings, watches and
other jewelry.
®
Wago
the Genie Service Parts
Department (Genie part number
33996).
1 Label the wiring from the component to be
removed.
2 Use a small screwdriver to push in and release
the wire from the component.
3 Locate the removal tab on the bottom or top
of the component.
4 Use a small screwdriver to gently pry up on the
tab of the component and remove it.
Part No. 65196
®
tools are available from
Genie S-60 & Genie S-65
Section 7 • Repair Procedures
9-4
Engine Fault Codes -
Gasoline/LPG Models
How to Retrieve Engine Fault
Codes
When a engine malfunction is detected by the
Electronic Control Module (ECM), a fault code is
recorded and the check engine light will turn
the ground and platform controls. Use the following
procedure to retrieve the engine fault code to
determine the engine malfunction.
Perform this procedure with the
key switch in the
1 Open the ground controls side turntable cover.
2 Open the ground control box and locate the run/
test toggle switch inside of the ground control
box.
3 Pull out the ground controls Emergency Stop
button to the position.
ON
4 Hold the run/test toggle switch to the test
position and turn the key switch to the ground
controls position.
Result: The check engine light should turn on.
The check engine light should begin to blink.
GROUND CONTROLS
at
ON
position.
OFF
7 - 39