Genie S-60 Service Manual page 279

Section 7 • Repair Procedures
4WD STEERING AXLE COMPONENTS
12 Use a slide hammer to remove the upper yoke
pivot pin, then use a soft metal drift to drive the
lower yoke pivot pin down and out.
Crushing hazard. The yoke/hub
assembly may become
unbalanced and fall when the yoke
pivot pins are removed if it is not
properly secured and supported
by the lifting jack.
13 Place the yoke/drive hub assembly on a flat
surface with the drive hub facing down.
14 Remove the drive hub mounting fasteners that
attach the drive hub to the yoke. Remove the
drive hub from the yoke.
Replace the thrust washer when
installing the yoke/drive hub
assembly onto the axle.
Torque specifications
Lug nut torque, dry
Lug nut torque, lubricated
Drive hub mounting bolts, lubricated
7 - 76
15-2
Steering Cylinders
How to Remove a
Steering Cylinder
This procedure is the same as the 2WD procedure.
See 14-2, How to Remove a Steering Cylinder .
15-3
Tie Rod
How to Remove the Tie Rod
This procedure is the same as the 2WD procedure.
See 14-3, How to Remove the Tie Rod .
How to Perform the Toe-in
Adjustment
This procedure is the same as the 2WD procedure.
420 ft-lbs
See 14-3, How to Perform the Toe-in Adjustment.
569.5 Nm
320 ft-lbs
434 Nm
180 ft-lbs
122 Nm
Genie S-60 & Genie S-65
Third Edition • First Printing
Part No. 65196