Perform Engine Maintenance - Deutz Models; Check The Hydraulic Filter Condition Indicators - Genie S-100 Service Manual

Section 4 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-6
Perform Engine Maintenance -
Deutz Models
Engine specifications require that
this procedure be performed daily
or every 10 hours, whichever
comes first.
Required maintenance procedures and additional
engine information are available in the
Deutz F4L913 Operation Manual
(Deutz part number 0297 9690).
Deutz F4L913 Operation Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
4 - 10
A-7
Check the Hydraulic Filter
Condition Indicators
Maintaining the hydraulic filters in good condition is
essential to good system performance and safe
machine operation. The filter condition indicators
will show when the hydraulic flow is bypassing a
clogged filter. If the filters are not frequently
checked and replaced, impurities will remain in the
hydraulic system and cause component damage.
62446
1 Start the engine from the ground controls.
2 Press and release the engine idle select button
to change the engine rpm to hight idle.
S-100 & S-105 & S-120 & S-125
January 2010
Genie requires that this procedure
be performed daily.
There are four hydraulic filters on
the machine: one tank return filter,
one medium pressure filter and two
high pressure filters. All the filters
have condition indicators on them,
except the medium pressure filter.
Part No. 62401
REV A