Engine Cranks Over But Will Not Start - Diesel Models - Genie S-60 Service Manual

Third Edition • First Printing
Engine Cranks
Over But Will
Not Start -
Diesel Models
Be sure to check the
engine oil level and fill
as needed.
Be sure to check
fuel level.
Be sure the fuel
shut-off valve is in
the position.
ON
Be sure that the battery
is fully charged.
Part No. 65196
less
Move the start toggle
than
switch to either side and
11V
check battery voltage
while engine is cranking.
11V or more
Disable the starter by
removing the blk wire at
12V
the starter solenoid.
Move the start toggle
switch to either side and
check the voltage at
positive terminal on fuel
solenoid.
0V
Move the start toggle
12V
switch to either side and
check voltage at wht
#21 wire on terminal #87
of CR2.
0V
Check voltage at red
0V
wire on terminal #30 of
CR2.
12V
Continued on the next
page.
Genie S-60 & Genie S-65
Section 5 • Troubleshooting Flow Charts
Check battery condition
OR check alternator OR
check for short circuits
OR check battery cables
OR replace the battery.
0 or
Turn the machine off
infinite
and isolate the fuel
ohms
solenoid. Check the
resistance of the
solenoid.
3.5 ohms Deutz
11.5 ohms Perkins
See Deutz or Perkins
service manual for
troubleshooting fuel
system.
Repair open in wht #21
wire from CR2 to fuel
solenoid.
Repair open in red wire
circuit from battery to
CB1 to CR1 to CR2.
Chart 3
Replace the fuel
solenoid.
5 - 13