2Wd Steering Axle Components; Yoke And Hub - Genie S-60 Service Manual

Third Edition • First Printing
14-1

Yoke and Hub

How to Remove the Yoke
and Hub
1 Remove the pin retaining fastener from the
steering cylinder rod-end pivot pin and the tie
rod clevis pin. Remove the pivot pins.
a tie rod
b axle
c yoke pivot pin
d yoke
e hub
f clevis pin
g steering cylinder
Part No. 65196

2WD Steering Axle Components

Genie S-60 & Genie S-65
Section 7 • Repair Procedures
2 Loosen the wheel lug nuts. Do not
remove them.
3 Block the non-steering wheels, and center a
lifting jack of ample capacity under the steering
axle.
4 Raise the machine approximately 6 inches
(15 cm) and place blocks under the chassis for
support.
5 Remove the lug nuts. Remove the tire and
wheel assembly.
6 Remove the pin retaining fasteners from the
yoke pivot pins.
7 Support and secure the yoke/hub assembly to a
lifting jack.
8 Use a slide hammer to remove the upper yoke
pivot pin.
9 Use a soft metal drift to drive the lower yoke
pivot pin down and out.
Crushing hazard. The yoke/hub
assembly could become
unbalanced and fall when the yoke
pivot pins are removed if it is not
properly supported and secured to
the lifting jack.
Torque specifications
Lug nut torque, dry
Lug nut torque, lubricated
420 ft-lbs
569.5 Nm
320 ft-lbs
434 Nm
7 - 71