Genie S-60 Service Manual page 30

Section 4 • Scheduled Maintenance Procedures
MAINTENANCE INSPECTION REPORT
Instructions
· Make copies of this report to use for
each inspection.
· Select the appropriate checklist(s) for
the type of inspection to be
performed.
Daily or 8 hour
Inspection:
Quarterly or 250 hour
Inspection:
Six Month or 500 hour
Inspection:
Annual or 1000 hour
Inspection:
2 Year or 2000 hour
Inspection: A+B+C+D+E
· Place a check in the appropriate box
after each inspection procedure is
completed.
· Use the step-by-step procedures in
section 4 to learn how to perform
these inspections.
· If any inspection receives an "N", tag
and remove the machine from
service, repair and re-inspect it. After
repair, place a check in the "R" box.
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
Comments
4 - 4
Checklist C
C-1 Engine belt-
Deutz models
C-2 Valves-Deutz models
C-3 Fuel filter/water
separator-Perkins models
C-4 Fuel filter-
Perkins models
A
C-5 Replace engine oil and
filter-Perkins models
A+B
C-6 Glow plugs-
Perkins models
A+B+C
C-7 Check the coolant-
Liquid cooled models
A+B+C+D
C-8 PCV valve-Ford models
Checklist D
D-1 Boom wear pads
D-2 Free-wheel configuration
D-3 Turntable bearing bolts
D-4 Grease rotation bearing
D-5 Drive hub oil
D-6 Drive loop hydraulic filter
D-7 Replace engine oil and
filter-Deutz models
D-8 Fuel strainer-
Deutz models
D-9 Fuel filter/water
separator-Deutz models
D-10 Change fuel lines-
Deutz models
D-11 Valves-Deutz models
D-12 Clean engine breather-
Perkins models
Genie S-60 & Genie S-65
Third Edition • First Printing
Y N R Checklist E
E-1 Hydraulic oil
E-2 Engine coolant-
Liquid cooled models
E-3 Fuel hoses-Ford models
E-4 Replace engine
breather-Perkins models
E-5 Wheel bearings
Perform every 3000 hours:
E-6 Fuel injectors-
Perkins models
Y N R
Y N R
Part No. 65196