Replace The Engine Oil And Filter-Deutz Diesel Models - Genie S-60 Service Manual

Third Edition • First Printing
D-7
Replace the Engine Oil and Filter-
Deutz Diesel Models
Periodic replacement of the engine oil and
filter is essential to good engine performance.
Operating the machine with an improper oil level or
neglecting periodic oil and filter changes can
damage engine components. A frequent check
of elapsed machine hours against the hours
noted on the oil filter will allow the inspector to
anticipate and perform oil and filter changes at
the 1000 hour interval.
Bodily injury hazard. Beware of
hot engine parts and oil. Contact
with hot engine oil and/or engine
parts may cause severe burns.
Perform this procedure after
warming the engine to normal
operating temperature.
1 Remove the oil filler cap, located next to the
dipstick.
2 Pull the end of the engine oil drain hose out
from under the engine.
Part No. 65196
Section 4 • Scheduled Maintenance Procedures
3 Remove the plug from the end of the drain hose
and allow all of the oil from the engine to drain
into a suitable container. See capacity
specifications.
4 Install and tighten the plug in the drain hose.
5 Use an oil filter wrench and remove the oil filter.
c
6 Apply a thin layer of clean engine oil to the new
filter gasket. Install the filter and tighten it
securely by hand.
7 Use a permanent ink marker to write the date
and number of hours from the hour meter on
the oil filter.
Genie S-60 & Genie S-65
TABLE D PROCEDURES
Do not remove the drain plug
located on the side of the oil pan.
Deutz Diesel engine
a engine oil level dipstick
b fuel filter
c oil filter
a
b
4 - 67