Replace The Drive Loop Hydraulic Filter - Genie S-60 Service Manual

Section 4 • Scheduled Maintenance Procedures
TABLE D PROCEDURES
D-6
Replace the Drive Loop
Hydraulic Filter
Replacing the drive loop hydraulic filter is essential
to good machine performance and service life. A
dirty or clogged filter may cause the machine to
perform poorly and continued use may cause
component damage. Extremely dirty conditions
may require that the filter be replaced more often.
Bodily injury hazard. Beware of
hot oil. Contact with hot oil may
cause severe burns.
Perform this procedure with the
engine off.
1 Locate the drive loop hydraulic filter mounted on
the engine near the pump.
2 Remove the filter housing by using a wrench on
the nut provided on the bottom of the housing.
3 Remove the filter element from the housing.
4 - 66
4 Inspect the housing seal and replace it if
necessary.
5 Install the new filter and hand tighten the
housing onto the filter head.
6 Start the engine from the ground controls.
7 Inspect the filter assembly to be sure that there
are no leaks.
8 Clean up any oil that may have spilled during
the installation procedure.
Drive loop hydraulic filter
Genie part number
Genie S-60 & Genie S-65
Third Edition • First Printing
20880
Part No. 65196