Change The Fuel Hoses - Gasoline/Lpg Models - Genie S-60 Service Manual

Section 4 • Scheduled Maintenance Procedures
TABLE E PROCEDURES
13 Check the coolant level in the coolant recovery
tank. Add coolant if needed.
14 Swing the engine pivot plate back to its original
position and install the two engine pivot plate
retaining bolts.
15 Start the engine from the ground controls
and let it run until it reaches normal operating
temperature.
16 Turn the engine off. Allow the engine to cool.
17 Check the coolant level in the coolant recovery
tank. Add coolant if needed.
Coolant capacity
Ford LRG-425 EFI Engine
Perkins 704-30 Engine
4 - 76
11.5 quarts 10.9 liters
10 quarts 9.5 liters
Genie S-60 & Genie S-65
E-3
Change the Fuel Hoses -
Gasoline/LPG Models
Maintaining the fuel hoses in good condition is
essential to safe operation and good engine
performance. Failure to detect a worn, cracked or
leaking fuel hose may cause an unsafe operating
condition.
Explosion and fire hazard. Engine
fuels are combustible. Replace the
fuel lines in an open, well-
ventilated area away from heaters,
sparks, flames and lighted
tobacco. Always have an
approved fire extinguisher within
easy reach.
Component damage hazard. Be
sure the fuel hoses are routed the
same way the original hoses were.
Perform this procedure with the
engine off and cooled.
1 Tag, disconnec and plug the fuel hose from the
fuel tank at the manual shutoff valve.
Third Edition • First Printing
Part No. 65196