Genie S-60 Service Manual page 219

Section 7 • Repair Procedures
PLATFORM COMPONENTS
5 Support the platform rotator with an appropriate
lifting device. Do not apply any lifting pressure.
6 Support the platform leveling slave cylinder.
Protect the cylinder rod from damage.
7 Remove the pin retaining fasteners from both
the slave cylinder rod-end pivot pin and the
rotator pivot pin.
8 Use a soft metal drift to remove both pivot pins.
Remove the platform rotator from the machine.
Crushing hazard. The platform
rotator could become unbalanced
and fall if it is not properly
supported.
7 - 16
How to Bleed the Platform
Rotator
1 Connect a clear hose to the top bleed valve.
Place the other end of the hose in a container
to collect any drainage. Secure the container to
the boom.
2 Move the platform rotate toggle switch to the left
and then to the right through two platform
rotation cycles, continue holding the switch to
the
RIGHT
right.
Genie S-60 & Genie S-65
Third Edition • First Printing
Do not start the engine. Use
auxiliary power for all machine
functions in this procedure.
d c
a top bleed valve
b bottom bleed valve
c clear hose
d container
until the platform is fully rotated to the
a
b
Part No. 65196