Genie S-60 Service Manual page 103

Third Edition • First Printing
2 Remove the 2 engine pivot plate retaining bolts
and swing the engine out away from the
machine to access the fuel hoses.
a
b
a engine pivot plate
b pivot plate retaining bolts
c air baffle
3 Place a suitable container under the engine
pivot plate. See capacity specifications.
4 Locate the fuel pressure regulator/filter and the
fuel pump on the engine pivot plate behind the
engine.
5 At the fuel pressure regulator/filter, disconnect
the fuel hose to the fuel tank.
Explosion and fire hazard.
Electronic Fuel Injection (EFI)
systems operate at a very high
pressure. Fuel may be expelled
under pressure if the hoses are
removed too quickly. Loosen the
fuel hoses very slowly to allow the
fuel pressure to dissipate
gradually. Wrap a cloth around
fuel hoses to absorb leaking fuel
before disconnecting them.
Part No. 65196
6 Remove and replace all of the fuel hoses and
c
b
7 Clean up any fuel that may have spilled during
8 Start the engine from the ground controls.
9 Swing the engine pivot plate back to its original
Genie S-60 & Genie S-65
Section 4 • Scheduled Maintenance Procedures
TABLE E PROCEDURES
clamps according to the following hose routing
diagram:
a
e
a high pressure hose from fuel pump to
regulator/filter
b hose from fuel pre-filter to fuel pump
c hose from fuel tank to fuel pre-filter
d high pressure hose from regulator/
filter to engine
e hose from regulator/filter to tank
this procedure.
Inspect the fuel filter and hoses for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
position and install the two engine pivot plate
retaining bolts.
c
b
d
4 - 77