Grease The Turntable Rotation Bearing And Rotate Gear; Replace The Drive Hub Oil - Genie S-60 Service Manual

Section 4 • Scheduled Maintenance Procedures
TABLE D PROCEDURES
D-4
Grease the Turntable Rotation
Bearing and Rotate Gear
Yearly application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an improperly greased bearing and gear will
result in component damage.
1 Locate the grease fitting on the platform end of
the tank side bulkhead.
2 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments
of 4 to 5 inches (10 to 13 cm) at a time and
repeat this step until the entire bearing has
been greased.
3 Apply grease to each tooth of the drive gear,
located under the turntable.
Grease type
4 - 64
Multipurpose grease
Genie S-60 & Genie S-65
D-5

Replace the Drive Hub Oil

Replacing the drive hub oil is essential for good
machine performance and service life. Failure to
replace the drive hub oil at yearly intervals may
cause the machine to perform poorly and
continued use may cause component damage.
Drive Hubs:
1 Select the drive hub to be serviced. Drive the
machine until one of the two plugs is at the
lowest point.
2 Remove both plugs and drain the oil into a
suitable container.
3 Drive the machine until one plug is at the top
and the other is at 90 degrees.
4 Fill the hub with oil from the top hole until the oil
level is even with the bottom of the side hole.
Apply pipe thread sealant to the plugs. Install
the plugs.
5 Repeat steps 1 through 4 for all the other drive
hubs.
Oil capacity per hub
Type: SAE 90 multipurpose hypoid gear oil - API
service classification GL5
Third Edition • First Printing
44 fl oz
1.30 liters
Part No. 65196