Test The Oscillate Axle (If Equipped) - Genie S-60 Service Manual

Third Edition • First Printing
A-10
Test the Oscillate Axle
(if equipped)
Proper axle oscillation is essential to safe machine
operation. If the axle oscillation system is not
operating correctly, the stability of the machine is
compromised and it may tip over.
1 Start the engine from the platform controls.
2 Drive the right steer tire up onto a 6 inch
(15 cm) block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
3 Drive the left steer tire up onto a 6 inch (15 cm)
block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
4 Drive both steer tires up onto a 6 inch (15 cm)
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
If the chassis does not remain
level during test, see Repair
Procedure 11-6, How to Set Up
the Directional Valve Linkage OR
see Repair Procedure 11-5, How
to Adjust the Oscillate Sequencing
Valve Pressure.
Part No. 65196
Section 4 • Scheduled Maintenance Procedures
Genie S-60 & Genie S-65
TABLE A PROCEDURES
4 - 11