Genie S-60 Service Manual page 240

Third Edition • First Printing
2 Locate the oil pressure and coolant temperature
sending units.
a oil pressure sending unit
b coolant temperature sending unit
(hidded from view)
3 Tag and disconnect the wiring from the desired
sending unit. Remove the sending unit from the
engine block.
4 Install the new sending unit. Do not over tighten.
Part No. 65196
5 Connect the wires to the new sending unit.
a
b
Coolant temperature sending unit specifications
Torque
Hex size
Temperature switch point
Oil pressure sending unit specifications
Torque
Hex size
Oil pressure switch point
Genie S-60 & Genie S-65
Section 7 • Repair Procedures
FORD ENGINE LRG-425 EFI
Burn hazard. Contact with hot
engine fluids or components may
cause severe burns.
Always use pipe thread sealant
when installing a sending unit.
8-10 ft-lbs
11-14 Nm
13
/ inch
16
230° F
(110° C)
8-10 ft-lbs
11-14 Nm
1
1 / inch
16
8 psi
0.55 bar
7 - 37