Coolant Temperature And Oil Pressure Gauges - Genie S-60 Service Manual

Section 7 • Repair Procedures
FORD ENGINE LRG-425 EFI
8-3
Coolant Temperature and Oil
Pressure Gauges
The engine coolant temperature gauge is an
electrical gauge. The engine coolant temperture
sending unit has limit contacts that are factory set.
The contacts will close at pproximately 230° F
(110° C). When the contacts close, the engine will
shut off to prevent damage and will not start until
the temperature drops below the contact point.
Engine coolant temperature will be indicated on the
gauge when the key switch is
Emergency Stop button is pulled out to the
position.
The oil pressure gauge is an electrical gauge. The
oil pressure sending unit has limit contacts that
are factory set. The contacts will open at
approximately 8 psi (0.55 bar). When the contacts
close, the engine will shut off to prevent damage.
Engine oil pressure will be indicated on the gauge
when the engine is running.
7 - 36
and the
ON
ON
Genie S-60 & Genie S-65
How to Remove the Coolant
Temperature and Oil Pressure
Gauge Sending Units
Perform this procedure with the
engine off.
1 Remove the 2 engine pivot plate retaining bolts.
Swing the engine pivot plate away from the
machine to access the coolant temperature and
oil pressure sending units.
a
b
a engine pivot plate
b pivot plate retaining bolts
c air baffle
Third Edition • First Printing
c
b
Part No. 65196