Genie S-60 Service Manual page 88

Section 4 • Scheduled Maintenance Procedures
TABLE D PROCEDURES
5 Manually rotate each non-steering wheel.
Result: Each non-steering wheel should rotate
with minimum effort.
6 Re-engage the drive hubs by turning over
the hub disconnect caps. Rotate each wheel to
check for engagement. Lift the machine and
remove the blocks.
Collision hazard. Failure to
re-engage the drive hubs could
result in death or serious injury
and property damage.
Steer wheels: 4WD models
7 Chock the non-steering wheels to prevent the
machine from rolling.
8 Center a lifting jack of ample capacity
(20,000 lbs/9072 kg) under the drive chassis
between the steer wheels.
9 Lift the wheels off the ground and then place
blocks under the drive chassis for support.
10 Disengage the drive hubs by turning over the
drive hub disconnect caps on each steer wheel
hub.
4 - 62
disengage position
engage position
Genie S-60 & Genie S-65
11 Manually rotate each steer wheel.
Result: Each steer wheel should rotate with
minimum effort.
12 Re-engage the drive hubs by turning over
the drive hub disconnect caps. Rotate each
wheel to check for engagement. Lift the
machine and remove the blocks.
Collision hazard. Failure to
re-engage the drive hubs could
result in death or serious injury
and property damage.
All models:
13 Be sure the free-wheel valve on the drive pump
is closed (clockwise).
The free-wheel valve is located on
the drive pump, and should always
remain closed.
a
a drive pump
b free-wheel valve
c lift pump
d screwdriver
Third Edition • First Printing
Part No. 65196
d
c
b