Genie S-60 Service Manual page 220

Third Edition • First Printing
3 Open the top bleed valve, but do not remove it.
4 Move the platform rotate toggle switch to the
until the platform is fully rotated to the left.
LEFT
Continue holding the switch until air stops
coming out of the bleed valve. Close the bleed
valve.
Crushing hazard. Keep clear of
the platform during rotation.
5 Connect the clear hose to the bottom bleed
valve. Open the bottom bleed valve, but do not
remove it.
6 Hold the platform rotate toggle switch to the
until the platform is fully rotated to the
RIGHT
right. Continue holding the switch until air stops
coming out of the bleed valve. Close the bleed
valve.
Crushing hazard. Keep clear of
the platform during rotation.
7 Remove the hose from the bleed valve and
clean up any hydraulic oil that may have spilled.
8 Rotate the platform full right, then full left and
inspect the bleed valves for leaks.
Part No. 65196 Genie S-60 & Genie S-65
Section 7 • Repair Procedures
PLATFORM COMPONENTS
7 - 17