Engine Low Idle Inoperative - Diesel Models - Genie S-60 Service Manual

Third Edition • First Printing
Engine
Low Idle
Inoperative -
Diesel Models
Check if
mechanical linkage
from 2-speed solenoid
to fuel
injection system is
binding or defective.
Part No. 65196
At the platform controls,
start the engine and
12V
move the RPM select
toggle switch TS4 to
maintained low idle
(turtle symbol). Check
voltage at blk/red wire
on RPM select toggle
switch.
0V
12V
Check voltage at the
blk/red wire on the
2-speed solenoid.
0V
solenoid
binds
Check if 2-speed
solenoid moves in and
out freely.
moves freely
Check adjustment of
linkage and fuel injection
system low idle. See
Maintenance section.
ok
See Deutz OR Perkins
workshop manual to
troubleshoot fuel
injection system OR
consult Genie Industries
Service Department.
Genie S-60 & Genie S-65
Section 5 • Troubleshooting Flow Charts
Isolate the platform and
ground RPM select
toggle switches TS4 and
TS12, check individually
and replace faulty toggle
switch.
Replace CR4 relay.
Check linkage or
replace solenoid.
Chart 9
5 - 23